A Gift for You!

I made 11 of these gift cards for our NEPA Stamp & Swap that was held a few weeks ago.

I wanted something fairly simple so I decided to use the Stampendous Gift Card Wallet Dies so I didn't have to do all the cutting, scoring, etc.  This is a very nice die set with several options of accessories to go with the basic gift card die.

I chose a DSP with snowflakes for the mat.  I was going to try to cut the notches for the gift card at the same time but I couldn't get it centered so I decided to make a 2nd pass.

Once the mat was cut, I used sticky notes to hold the notch die in place.  Probably could have done that when I cut the mat.  Oh well you know what they say about hind sight...LOL!

I used Stampendous Penguin Gift Stamp Set stamped in Memento Lux Back Ink.  I probably wouldn't use this ink again because it dries VERY slow even after heat setting it.  I just love those penguins & that cute snowman!

I recently rediscovered coloring with pencils & gamsol blending solution. 

After coloring the penguins, I used a light gray marker under them.  I stamped the snowflakes around the penguins in tumbled glass.

This was the finished inside.

I made a small tag with one of the sentiments in the stamp set & add a silver brad.  It was attached to the back of the outside after I had stamp "to:" & "from:".


 

Christmas Gift Card Holder

Another swap for our Jingle All The Way SCS Event is a Christmas Gift Card Holder.  I found several designs on Pinterest but decided to do one I saw by Tara Bazata using an envelope.  I did make a couple of changes but the basics are the same.

I started with a SU Crumb Cake Envelope, folded it in half & used a bone folder to make a crisp crease. Using a trimmer, I cut half the flap off then adhered the other side down.

I made three panels using SU Mossy Meadow CS cut 2 11/16 X 4 1/4 for the base; two with DSP from SU Home for Christmas & one in SU Crumb Cake cut 2 1/2 X 4.

To add the Real Red Holly Berry Bouquet Button, I measured up 3/4 from the bottom in the middle using my Tim Holtz ruler then punched a small hole.

I cut 11" of jute thread & put it through the button & tied it at the back.  The thread was pulled through the hole in the panel & scotch tape to holds it in place.  I placed 1/2" Scor-tape on the back of the panel.

The front panel has "To" & "From" from SU Old Fashioned Christmas set & a pine bough from SU Christmas Punch set stamped in SU Mossy Meadow on the SU Crumb Cake.  The jute thread was taped down & this panel was adhered over top of the jute using Scor-tape.



The last panel was adhered on the inside over the envelope flap that was adhered down. I make one mistake on the next part. I had stamped the sentiment on the envelope but I didn't like the direction so I cut another panel of Mossy Meadow 2 11/16 X 3 1/2 then added a piece of Crumb Cake cut 2 1/2 X 3 1/4. I then stamped the sentiment from SU Wishing You Cherry in Real Red Ink. This boo boo made the card a little thicker than I wanted it to be but oh well. As you can see the gift card slips into the envelope!

I made a small tag using a stamp from SU Christmas Punch set. It was inked with Mossy Meadow then I wiped the poinsettia leaves off & inked them with a Real Red marker. Once dry, I used a Gold Star Gelly Roll pen on the center & Clear Wink of Stella on the leaves. It was punched out using a SU Medium Scallop Punch. & adhered with mono adhesive. The thread is long enough to wrap around the button to keep it closed.

Maybe it's a little elaborate for a gift card but it sure is pretty!! TFL!